General Description

The A2e Technologies E2cB01 dongle pair is a special purpose device allowing transmission of full-duplex Ethernet traffic over 75 Ohm coaxial cable.

The dongles allow one to upgrade from an analog camera installation to an IP camera system without having to install new Ethernet wiring by allowing transmission of Ethernet data over existing coax cabling. This saves significant time and money.

Each dongle has an Ethernet RJ45 jack and a coaxial connector. Simply plug the camera into the Ethernet jack and the Coax into the Coax connector on the camera side. On the other end of the coax run (typically the control room) connect the other dongle into the coax and then again in to the existing Ethernet network. That is it! 

Features

• Run standard IEEE 802.3 100BASE-TX traffic over standard 75 Ohm coaxial cable
• Long Distances: 100BASE-TX at 200meters of RG59 and 300 meters RG6 coaxial cable minimum, farther with 10BASE-T operation
• Instantaneous transmission, no buffering or delays
• 100Mbps Full Duplex Line speed up to rated distance (i.e. no throughput degradation as distances increase)
• Simple Installation: No programming or setup!
• Compatible with 10/100BASE-TX IP Network Devices
• Completely Software Transparent
• Remote camera side dongle requires no power!

Download the Data Sheet!

See our Data Sheet download link in the right column or click here: Download Data Sheet. The Data Sheet contains more details on functionality and deliverables. Or, you can contact the sales person in your area to learn more. (sales@A2eTechnologies.com, or numbers at the bottom of this page)

Where to buy

A2e Technologies is selling this product through the following partners:

• CALL OR EMAIL FOR LIST

Or please contact us at sales@A2eTechnologies.com for pricing and any other questions.